Introduction
Windows installation is a bit more tricky since "pecl install imagick" does NOT work properly.
Here's how I installed it:
1/ Install ImageMagick software http://www.imagemagick.org/script/binary-releases.php#windows
2/ Download pecl-5.2-dev.zip (choose the version relevant to your PHP) from http://snaps.php.net/
3/ Copy php_imagick.dll from the archive you've downloaded to your PHP extention folder.
4/ Add the following line to php.ini (in the exntentions section):
extension=php_imagick.dll
5/ Restart your server
6/ Try the example script to see all went well
Good luck :)
Installing/Configuring
Table of Contents
Requirements
Installation requirements on Windows
Version information does not differ from that above. There are binaries available from http://imagemagick.org/ so that you can load this extension on Windows without need for a compiler.
Installation requirements on other platforms
PHP >= 5.1.3 and ImageMagick >= 6.2.4 is required. The amount of formats supported is by Imagick is entirely dependent upon the amount of formats supported by your ImageMagick installation. For example, Imagemagick requires ghostscript to conduct PDF operations.
add a note
User Contributed NotesInstalling/Configuring
colnector is from domain colnect.com
13-Jul-2008 02:10
13-Jul-2008 02:10
james dot ellis at gmail dot com
09-Jun-2008 03:21
09-Jun-2008 03:21
To install the latest Imagick from PECL on an Ubuntu variant system, assuming your already have PHP5 and Apache2 installed, do the following.
You need your root password, have sudo privileges and be able to run commands from a shell (e.g via Konsole)
1. $ sudo aptitude install php-pear imagemagick php5-dev libmagick9-dev
2. do *not* install php5-imagick as you will install a later version from PECL
3. libmagick9-dev may install a whole load of dependencies. This package provides the Wand-config program and avoids the error on pecl install "configure: error: not found. Please provide a path to MagickWand-config or Wand-config program."
4. $ sudo pecl install Imagick
5. Hit enter to autodetect the "Imagemagick installation" prefix
You should see some compilation messages, noting any errors that stop the Imagick build.
When completed successfully, the following console message should appear
Build process completed successfully
Installing '/usr/lib/php5/20060613+lfs/imagick.so'
install ok: channel://pecl.php.net/imagick-2.2.0b2
Now for loading it when the web server starts/restarts
6. $ sudo kate /etc/php5/apache2/conf.d/imagick.ini
7. enter extension=imagick.so and save
8. $ sudo apache2ctl configtest
9. $ sudo apache2ctl restart
Notes:
* You can use any apt client e.g apt-get to install packages
* If you want beta Imagick then:
$ sudo pear config-set preferred_state beta
* You can now upgrade Imagick as new versions are made available in PECL the same way PEAR updates are handled.
Hope this helps some of you...